I need to go from 3 inch tubing to a 4inch mass air sensor. the only silicon transitions I can fine are 3- 3 1/2 or 3 1/2 to 4.

Does anyone know if a 3in to 3 1/2 inch transition will strech to 4 inch to fit on the 90mm mass air meter?

 

not to sound like a hack but they have nice black plumbing ruber hose trans at home depot-been there done that

 

yeah thats basically it. or you take your 3 to 3.5 and your 3.5 to 4 and mate the two 3.5 sides together. i'm sure you can do it without it looking too bad...you could always just use duct tape and zip ties...

 

yeah because 15+ lbs of boost aint gonna blow that shit out

 

Hmmm lets see the fitting that you will be buying at an outragious (sp?) price is made out of silicone and the fittings at home depot are silicone no difference! And we use them on 80 p.s.i. water lines all the time. Don't let the place where you purchase scare you away from a availibility and price

 

The guy I bought my couplers from can make whatever you want I think. I'll see if I still have his link when I get home.

 

just got some of these....nice stuff

 

duct tape

i think $hawns idea may be better though

 

I was refering to the post that said use a 3 to3.5 hooked to a 3.5 to4 .. i buy stuff from the depot all the time.


FUCKING ROCK OUT WITH YOUR COCK OUT $hawn! thoose prices are awesome! Way cheaper then the cheapest ive found~! and they have what i need. I own you a freaken beer man!

 

and they shipped the shit fast too!!!!! check the prices on the t-bolt clamps