I am not a mustang owner so sorry for the stupid question im about to ask.

I have a nissan 240sx with a 2.4L motor but the factory 5spd is not going to hold the power output, so I am converting the tranny to a C4. I have a factory 5.0 manual driveshaft off a fox body but I don't have the tranny yet and I was wondering if the yoke will fit the C4 transmission? Please I need your help THANKS.

 

Im pretty sure the drive shaft for the ford will be a thicker diameter. Call up a drive shaft shop. for a plain steel driveshaft custom made is cheap as shit. I used to get the TH400 to Dana60 drive shafts up north for 200 and change a piece from a local company. Call them ask alot of questions take EXACT measurements then measure again then get them to make ys one up

 

I'm pretty sure they are the same....5 speed to AOD fit...I'm sure C4 also....I'vedone it.

 

Drive Shaft Specialist...

 

Thanks for the info everyone it really helps.

 

hes putting it in a 240sx pat ..

 

Its the same! 5-speed, AOD, C-4, C-5

 

Wow i didnt know that the 240sx had the exact same driveshaft length as a stang .. good to know

 

I have a factory 5.0 manual driveshaft off a fox body but I don't have the tranny yet and I was wondering if the yoke will fit the C4 transmission
YES, THE YOKE IS THE SAME, Length is a different story