Your'e lucky you didn't turn around Dan! I would have whooped your broke azz car!! haha...easy kill.....too bad the po po was on that corner!! haha!!

 

ok found out what was wrong combo of a fuel pump a little on the weak side and the 511 code was being thrown because a "undisclosed FORD specialty SPEED shop" chaffed my power wire to my ECU when they pulled it out and left it hanging, this is the reason it started right after my last program being burned it didnt show on the dyno because it was stationary but when the chassis moved it caused it to ground out on the chassis. this is why it happened when I took off and at every shift.so it was undetectable by dyno tuning. oh well learned my lesson to go to the teacher not the hard headed student with poor buisness skills.(I have mentioned no names so there is no reason to lock this thread.)

 

later pat we will run even though you have cubes and weight on your side.

 

how did ramseys re-tune your chip with out removing your computer?

you cant really be certain who frayed your wire.

 

It's obvious as to what you're doing, and personally I think it's bullshit. Why not man up and talk to the people who you had work on the car instead of playing these games?

 

I gave them 4 chances to correct their problem and they did nothing but try to push it on to the chip manufacturer who tried doing their best but I was ready to move on til they started it back up again I will not attack anyone but I will defend myself when provoked.and ramsey's didnt have to remove it. it was left out by the previous shop.notice I am not mentioning any names only those who have done good work. btw the chip manufacturer said to take the chip back to the original shop for a refund and repurchase it from ramsey's but I chose not to do so just to spend my future dollars elsewhere,I have not unjustly slammed anyone. I dropped it, even wished them luck and said God Bless them, what else do you want? I was the victim here! not the other shop.I'm done with them and will no longer speak their name or give them publicity negative or positive.It is over as far as I am concerned.if other people have problems so be it. CONSIDER THIS A DEAD ISSUE.

 

Get ready to lock this thread also. Dan you are full of shit. I burned one chip and said try it out. You gave me the other programs that I burned to a chip that you got from superchips. I had nothing to do with those chips!!!! You were the one that talked to superchips because you read some magazine article and it had the same transmission setup as you have. Bottom line, I sold you a basic chip out the door and YOU installed the chip. You talked to superchips and you wanted me to burn the superchips programs to the chip and I burned it and installed it for free and gave you the 4 position cable and never asked for a dime. As for the bullshit of giving us 4 tries to get this right, I know I am not a brilliant businessman (just a hard headed student) but I can count, and by my count it was only twice that I had seen the car ( once that I handed you a chip to install ,and once to install some programs that Superchips gave you.) I never tried to push it off on superchips, YOU were the one that said that they fucked up until I went out there and your mass air meter was falling off the car ( or do you forget that part) And don't forget the burned up plug wire. So If it was running so good why was the computer not installed back into the cage? So quit blaming everyone else because your car is a pile

 

Lets get ready to Rummbblleeeeeee.

 

Truth got your tongue?

 

why are you hijacking my thread in the first place? the info came from SCT for the first burn because you didnt even know the ratios of the 4R70w.Not from a magazine, The Computer was not reinstalled by Ramsey's because He is tuning my Nitrous System this week yes its called repeat buisness with pay (must be foreign to you) I was willing to let things go away and not say another word on it but when I had the problem with Cold air tube it was because I just reinstalled it after putting on a new Strut Tower brace and it was rubbing loosening my clamp(silicone is slippery) so instead of you taking a minute to look into it you walked away (I guess you were busy ignoring the phone)btw tonight I was doing another foreign thing to you Helping customers. I deal with about 8-10 customers a day and would not hesitate to help them Even in the middle of the night.(I was out in the hurricane helping my customers and checking on their property for them-at no cost to them)this is called caring about your work and having pride in it.3rd foreign concept for you. LET THE SUBJECT DIE, DONE DONE DONE! what do you hope to gain from posting here? I will never use your buisness or services again, Get over it, I have not used your company name or your name in quite awhile so there is no link between you and this thread other than your posts.give it up I am holding no ILL WILL towards you.I'm just going somewhere else and am not slamming you or your buisness,If walmart did something wrong and I chose to shop at target, Walmart would not get angry and post insults towards me or my property,doing so would only make them look like an ass. so please stop hijacking my thread.
GOOD LUCK,GOD BLESS