Traction problems, new times
Domestic Disturbance
Joined: Jul 2003
Posts: 1,251
Likes: 0
you done any cams?
__________________
R.I.P Bryan Asay
Blonde girl 1: "Whasts a hemi?"
Blonde girl 2:"its a truck for a motor"
4 mechanically inclined guys:"what the fuck did you just say?"
R.I.P Bryan Asay
Blonde girl 1: "Whasts a hemi?"
Blonde girl 2:"its a truck for a motor"
4 mechanically inclined guys:"what the fuck did you just say?"
blowed up
Joined: Jun 2002
Posts: 2,978
Likes: 0
that gtec was very accurate cuz i ran the same one in my car that same nite and pretty much hit my 8th mile ets exactly matching my timeslips.. his 1st gear didnt get traction til higher rpms but once he hooked he pulled hard... i believe every bit of that 12.6 ET
__________________
T.R. $100,000 kill club member #002
Turtle crew member #2
Originally Posted by 05general lee
im FAT!!!!
Originally Posted by Little Nicky
Scott is my body guard
Turtle crew member #2
Breaking the Broken
Joined: Oct 2003
Posts: 359
Likes: 0
Originally posted by mustangman98
well, it has all forged internals with a PI head swap and pretty much every possible part that someone could put on it. long tubes, pullies, intake plentum from C&L, mass air meter, TB, aluminum driveshaft, 3:73 gears, king cobra clutch, and all controlled by a custom tuned diablo sport delta chip.
probably more stuff im just forgeting.
well, it has all forged internals with a PI head swap and pretty much every possible part that someone could put on it. long tubes, pullies, intake plentum from C&L, mass air meter, TB, aluminum driveshaft, 3:73 gears, king cobra clutch, and all controlled by a custom tuned diablo sport delta chip.
probably more stuff im just forgeting.
__________________
"Try to make ends meet
You're a slave to money then you die"
"Try to make ends meet
You're a slave to money then you die"
Breaking the Broken
Joined: Oct 2003
Posts: 359
Likes: 0
Re: Traction problems, new times
Originally posted by mustangman98
my best hp and torque are 300hp and 342 ft lbs.
my best hp and torque are 300hp and 342 ft lbs.
__________________
"Try to make ends meet
You're a slave to money then you die"
"Try to make ends meet
You're a slave to money then you die"
blowed up
Joined: Jun 2002
Posts: 2,978
Likes: 0
i believe the gtec does wheel hp but i could be wrong... it pretty much matched the hp readings from my dyno sheet but my torque was a little off
__________________
T.R. $100,000 kill club member #002
Turtle crew member #2
Originally Posted by 05general lee
im FAT!!!!
Originally Posted by Little Nicky
Scott is my body guard
Turtle crew member #2
Breaking the Broken
Joined: Oct 2003
Posts: 359
Likes: 0
it must be wheel HP and tourque cuz if i dont think he could of ran a 12.6 with 300 flywheel HP unless he has a lot of wight reduction and he is a bad ass drive which he might be. but nice numbers i want to use a g-tech on my car and see what i can do
__________________
"Try to make ends meet
You're a slave to money then you die"
"Try to make ends meet
You're a slave to money then you die"
car with tiny wheels
Joined: Nov 2003
Posts: 550
Likes: 0
im not doubting your runs at all but i have used the g tech pro in my car and it was crap, way off like it said i had 750 hp and 60 ft times were off too, tried in a friends car after a recalibration for his weight and it was still way off, he only uses it now for a shift light, im sure you can run some good times but i would just take it to the track to know for sure
__________________
in memory of Kevin Gonzalez 6/21/86 - 9/13/06
in memory of Kevin Gonzalez 6/21/86 - 9/13/06
blowed up
Joined: Jun 2002
Posts: 2,978
Likes: 0
Originally posted by CBRTRX
im not doubting your runs at all but i have used the g tech pro in my car and it was crap, way off like it said i had 750 hp and 60 ft times were off too, tried in a friends car after a recalibration for his weight and it was still way off, he only uses it now for a shift light, im sure you can run some good times but i would just take it to the track to know for sure
im not doubting your runs at all but i have used the g tech pro in my car and it was crap, way off like it said i had 750 hp and 60 ft times were off too, tried in a friends car after a recalibration for his weight and it was still way off, he only uses it now for a shift light, im sure you can run some good times but i would just take it to the track to know for sure
__________________
T.R. $100,000 kill club member #002
Turtle crew member #2
Originally Posted by 05general lee
im FAT!!!!
Originally Posted by Little Nicky
Scott is my body guard
Turtle crew member #2
