I'm look for 2 stock 52mm throttle plates for a 95-99 420s engine. If you have an extra t-body laying around in th garage, let me know. I'll meet up with you if it's not crazily far.

 

I have an extra 52mm TB for a DOHC neon engine...not quite the sameas a 420a, but....

 

If the plate is 52, then that will work.
How much you want for it?
When are you free for a visit?

 

$35 and its yours....I'm free to drive to meet somewhere just about anytime, tonight if you want...somewhere in Tampa?

 

No thanks, I can get the plate ALOT cheaper at a yard.

 

oh, you just mean the butterfly plate, yeah you probably could, cant get the TB cheaper though, well, I was going to use the TB eventually anyway, good luck in your search

 

oh, and just to let you know, any 1st gen neon will have a 52mm butterfly plate, the 5 speeds have a 49mm TB but that is because of the actual narrowing of the TB in a MTX, the plate is still 52mm

 

Thanks for the info. I'm gonna be using them on a t-body for an lt1 (it has 2 plates)...then I'm gonna force it on the saturn.

 

thats a lot of air for a 4 cylinder...heh

 

I don't want any retrictions at 18-22psi.

I found 2 plates some on the Plymouth varient...They neons were right next to each other. That 48-49 mm mouth makes throttle plate remove a slight pain in the ass, nothing a 12 er13mm and a 10mm couldn't take care of though, oh, and a hammer to remover the battery try

Thanks agian for the help.