Modded '03 Cobral with pulley.....
Guest
Posts: n/a
I raced a Mineral grey '03 Cobra last night heading onto Gandy, he has a 14 or 16lb pulley and exhaust, he was a half car ahead of me when we both hit it in 1st and I pulled along side him in second and stayed side by side through 3rd and had to let off due to traffic, it was a good close race, the guy goes to my gym so I'll see if I can catch up to him one night to get a full run in....anyways props to him.
Sounds like a good run..
__________________
Single Toyota Supra Auto, Twin Turbo C5 FRC, and Chevy Duramax!!
My email:
vince99frc@gmail.com
Single Toyota Supra Auto, Twin Turbo C5 FRC, and Chevy Duramax!!
My email:
vince99frc@gmail.com
Guest
Posts: n/a
Originally posted by Droptop Snake
Nice one. Your mods, aside from the obvious?
Nice one. Your mods, aside from the obvious?
damn will on the spray would have been anle 2 give that cobra a few cars and the hit if he was on the spray and good kill that cobra rides out 2 i got a ride in it
__________________

Yeah it's broken
-Cobra block
-Cobra crank
-Diamond pistons
-Eagle rods
-NOSzle Kit
-Bottle Heater
-QA1 K-Member
-D&D Tubular A-arms
-D&D Coil overs
-1/2' Intake spacer
-Windage tray
-80MM C&L
-K&N Filter
-FR Aluminum drive shaft
-Steeda G-trac bar
-Kenny Brown sub frames
-UPR shifter
-Spec clutch
-Spec Alumn Flywheel
-Steeda Clutch quadrant
-Steeda fire wall adj
-4:10 gear
-Mac upper adj control arms
-Mac Lower control arms
-Mac T/A girdle
-Steeda quad shocks
-Hooker long tubes
-DR.Gas X-pipe
Yeah it's broken-Cobra block
-Cobra crank
-Diamond pistons
-Eagle rods
-NOSzle Kit
-Bottle Heater
-QA1 K-Member
-D&D Tubular A-arms
-D&D Coil overs
-1/2' Intake spacer
-Windage tray
-80MM C&L
-K&N Filter
-FR Aluminum drive shaft
-Steeda G-trac bar
-Kenny Brown sub frames
-UPR shifter
-Spec clutch
-Spec Alumn Flywheel
-Steeda Clutch quadrant
-Steeda fire wall adj
-4:10 gear
-Mac upper adj control arms
-Mac Lower control arms
-Mac T/A girdle
-Steeda quad shocks
-Hooker long tubes
-DR.Gas X-pipe


