Well, had a buddy of mine roll into the shop today with his new ride and it was nice and clean (EG Civic Hatch Si). well we got to chit chatting and a few bs'ing words were tossed around about who would beat who, so we decided to take it to the dyno, but not after making it a fair heat up time. So we ran up and down 301 a little bit, obeying all traffic control devices might i add! Then we roll back into the shop, i leave my car running, strap him up, and run him. puts down 98/84 ft lbs. so im thinking this will be cake for the sentra. i roll his car off the dyno, park it, roll mine up, get it on and strapped up, then i hear him yell "You have to run on motor" and just to make it interesting i agreed. Got to 3rd gear, got up to about 3300 and hit it. i just wind out till a little before redline and prayed i won. stopped the dyno, went down to only see that he beat me by 4whp and 1wtq. i was so sad, but still in the back of my mind knew id beat him any day of the week.

 

My 4cyl. Magnum Dakota will own you both!!!!

 

very nicely done for the 1.6l how much would it cost for a baseline dyno pull for the 200sx for comparison with other dynos? pm me and let me know. and how soon I could get a run.. i only need 1 or 2 pulls. Thanks kenny

 

you could probably go down there anytime. i went last sunday and did 158/138 with the h22. plus its in brandon, right by brandon ford, so its pretty close.

good job kenny, did you dyno with the spray?

 

i dynoed on motor. but you have a pm jon, just gimme a ring at the shop and lemme know when ya wanna get on. 813-628-0080

 

Where do you work Kenny???

 

right across from Brandon Ford, basically 301 and 60/Adamo

 

the sentra kicks ass.i told you that was a street terror.

 

...i know you?

 

i changed my SN i sold you the car