So to save you some time here's the short version. The car is a 95 vr6 Basically i was replacing my passenger side axle and while in the process of putting the new one in i forced it to much and the bearing feel out of the axle. Basically the boot stayed still and the bearing and everything pushed out of the boot. The problem i have is where the axle goes into the tranny. I need help repacking the bearings. Does anyone now how to do this. Any help would be greatly appreciated!!!

 

where did you get the axles from. cause some places offer lifetime warranties and you just walk in and replace them.

 

Its a used axle, theres nothing wrong with it. I just need to know how to repack the bearings

 

Push the inner bearing back in as far as it will go and push the ball back in. it will be a tight squeeze. they will all go back in.

 

thanks, got it