I finally got my wheels and coilovers installed. I am going to lower the car about another 1/2 inch, when I get a chance.



18 x 8.5 et35 Flik's.... yea I know.

 

Oh man i see some pokeage... Definately wanna see the pics when its lower! Looks good man.

Btw are the rotors on this car?

 

Thanks, the wheels are almost flush right now... just a little poke. The driver side front wheel rubs on the coilover, so I will have to run a small spacer.

I should have the brakes mounted later this week.

 

what motor? and what coils?

 

It's a stock VR6.
I purchased the coilovers as a sample, they are the same design as B&G... threaded body

 

damn look pretty nice! slam it and test out how low they will go...i havnt put my konis all the way down yet, i have a vr too, and the coils are said to be for a 1.8 but it doesnt really make a difference

 

Are those coils the B&G that I seen all over the vortex?
And hey man, I dont care what anyone says, Flicks dont look bad at all, and not everyone can afford to go out and buy 2000 BBS wheels. Looksing good, and some 5mm on the front and some 10's on the back would set it out NICELY!

 

Hmm, what brand are those coils? The quality looks a little on the cheap side from the pics.. Cant tell though, Def post up some more pics once they are on and ready.

 

They aren't B&G, but are the same threaded body design.

I don't like the color combination. I would prefer a black spring and matching collars. They have a 46mm piston, HD seals and full dust boots. These aren't bad coilovers, this manufacturer sells an inverted coilover for the 240sx and I have a local car currently testing them and he is very pleased withtheir performance, but I am not going to buy/resell any more of the vw coils.

 

drop it to the ground...