need a price on a roll cage and dash
Thread Starter
SAVE THE SOHC!
Joined: Sep 2005
Posts: 4,614
Likes: 0
need a price on a roll cage and dash
i have a 90 ef hatch its completly guted and no dash in it i want 2inc pipeing for the roll cage the car has 2 racing sets welded in it i want pas out and a aluimim dash put in cage can be bolted in or welded dosnt matter
just give me a ruff estment and witch ever shop i decied with ill bring the car there for mesure ments and ezcaly how i want the cage no paint i can do all that post or pm me thx
just give me a ruff estment and witch ever shop i decied with ill bring the car there for mesure ments and ezcaly how i want the cage no paint i can do all that post or pm me thx
__________________
93 del sol si (project)
88 honda cvic ef (daily driver)
hit me up on fb ( www.facebook.com/stewartracing13 )
TR "Old Skool EF" Member #166
93 del sol si (project)
88 honda cvic ef (daily driver)
hit me up on fb ( www.facebook.com/stewartracing13 )
TR "Old Skool EF" Member #166
GO TOPLESS
Joined: Jul 2008
Posts: 68
Likes: 0
DCW sarasota 1100 in sarasota
__________________
I KNOW THIS, I BEEN SLIDING FOR A WHILE, JUS NEVER OWNED A 240, BUT DONT KNOW HAVE TO BE GOING LIKE 30 TO SPOOL UP IN 2ND. MIGHT B SOME HIGH SPEED ISH.. BUT WE WIL SEE WHAT HAPPINS
Thread Starter
SAVE THE SOHC!
Joined: Sep 2005
Posts: 4,614
Likes: 0
still looking for a roll cage 10 point
__________________
93 del sol si (project)
88 honda cvic ef (daily driver)
hit me up on fb ( www.facebook.com/stewartracing13 )
TR "Old Skool EF" Member #166
93 del sol si (project)
88 honda cvic ef (daily driver)
hit me up on fb ( www.facebook.com/stewartracing13 )
TR "Old Skool EF" Member #166
Budget Baller
Joined: Apr 2004
Posts: 1,594
Likes: 0
Your average shop is going to be charging about 125-150 per point for mild steel and 225-250 for chromoly.
Best thing to do is contact A.R.T in clearwater for a pre bent cage and get someone to weld it in.
Ad for the dash that will most likely run you around 200-350 depending on what you go with. I would do at very min 1/8 inch and rolled for strength. That's what I did in my car, It turned out nice and I put a back plate along the front for gauge support.
Best thing to do is contact A.R.T in clearwater for a pre bent cage and get someone to weld it in.
Ad for the dash that will most likely run you around 200-350 depending on what you go with. I would do at very min 1/8 inch and rolled for strength. That's what I did in my car, It turned out nice and I put a back plate along the front for gauge support.
Last edited by Sleeperlx; Dec 8, 2009 at 07:19 PM.
