2005 Toyota Matrix....cabin air filter

Reply Subscribe

Thread Tools

Mar 12, 2019 | 07:55 AM

#1 (permalink)

senor honda

Thread Starter

Registered

Joined: May 2005

Posts: 104,939

Likes: 21

2005 Toyota Matrix....cabin air filter

Instructions

This page and video will show the job done on a 2005 Toyota Matrix. As always—before any job—take a look at your service manual. If you don’t feel completely comfortable doing this yourself, we can refer you to a professional technician.

Step 1: Remove glove box pin

Open your glove box and locate this pin on the outside edge. Use your screwdriver to take the screw out, then slip the pin out of the hole on this arm. And put the screw someplace safe. Some vehicles will have a band holding the glove box in place that you’ll need to release.

Step 2: Lower glove box

Now, gently press in on both sides of your glove box and it will lower. This will expose what’s behind it, including this black cover, which is where your cabin air filter is. Most vehicles with a filter behind the glove box will be accessed like this. Just be careful not to force the glove box down—there will be a limited amount of slack in the hinges.

__________________
Here is the listings of ALL New Mexico Car Events Including Route 66 Anniversary
https://www.tamparacing.com/forums/t...ar-events.html
Top Car Club Meetings? Click a city
Got a video? Email it to Bobfixesitup@yahoo.com
________________________________________________

Keystone Motor Club (Founded 2012)... Free car show Every 3rd Saturday, newsletter is
https://www.tamparacing.com/forums/e...-car-club.html
Keystone picture gallery is here:
https://carstoshow.com/eventdetails.aspx?eventid=93202

Veterans and Friends on First Saturday...Some pictures....
https://carstoshow.com/registerevent...eventid=102331

Port Richey Rod Run at Coast Buick GMC
https://carstoshow.com/registerevent.aspx?eventid=99114

50's Diner US19.... A Florida Attraction.
1730 US-19, Holiday Fl 34691 click: https://www.tamparacing.com/forums/t...acing.html CHRA sanctioned cruise-in.
Cruise-In; Free; Every Saturday 5-8PM plus 10% off the whole menu to cruisers
50's Diner pictures are here: https://carstoshow.com/eventdetails.aspx?eventid=93194

All Cars Every 2nd Saturday Free Breakfast: Since 2015 and more. click: https://www.tamparacing.com/forums/e...ast-tampa.html

Tampa Racing.com covers the Tampa car scene and supports many fund raisers, worthy causes and events that enrich our community. We hope you enjoy them all.
What do I do? ---- on-site *Aftermarket* spring/suspension installations --- on-site impact wrenching---street lowering with your own stock springs...........True Bi-xenon HID projector headlight conversions........ Much more at Bob's Garage!
https://www.tamparacing.com/forums/b...ontact-us.html
https://www.tamparacing.com/forums/b...e-senor-honda/

Mar 12, 2019 | 07:55 AM

#2 (permalink)

senor honda

Thread Starter

Registered

Joined: May 2005

Posts: 104,939

Likes: 21

Step 3: Remove old filter

There are tabs on either side of this cover that are released by squeezing them inward. Once the cover is removed, pull the old filter out slowly—it’s likely to be full of dust and dirt.

Step 4: Clean the filter housing

Check the filter housing for excessive dirt or debris, and vacuum it out if necessary.

Step 5: Slide new filter in

When you go to put the new filter in, check the airflow arrow on the edge to make sure you’re getting it in place properly. Once it’s seated securely, replace the cover and snap it into place.

Step 6: Put glove box back

Lift your glove box back to its original position, and secure it by sliding the pin back into the hole in the arm, or putting the band back in place. Then, replace the screw, close the glove box, and you’re done.