Ok.. so, now I can get the car running off of a shot of gas into the intake.. then she runs on her own. Per Empire I pulled the fuel rail off with the injectors attached. I could see the start up spray for fuel being shot out.. and there was enough pressure to push two of the injectors off the rail. I need to switch a few things back to their proper positions.. IE fpr vacuums to individual fprs, fuel filter.. and I seem to be having a problem with one of the vacuum control sensors.. either its not hooked up right or its leaking vacuum. Hoping to get it all sorted out.
Still have to make intercooler piping since my vmount setup is so close..
Also need to have a drive shaft made.. for whatever reason the "drop in" rb20 trans wont fit with the one piece driveshaft. (even though I measured the rb trans and it was the same as the rb/ka trans.. and to add that the engine mounts and trans mounts are all hooked up in their same locations.

Lots of work to do.. but im glad that she runs..even if its taking a shot of gas to start

1. drive shaft
2. trans fluid
3. headlights( square hardbody lights since the vmount wont fit stock lights)
4. install the SAFC, boost guage, wideband
5. rip, shred, and put a JIHAD on my tires!