Ok, I kinda screwed meself. Here's the run down...

I started out w/ 30mil iron calipers w/ the proper rotors. I needed brake hardware so I bought the pins and
shit...-$42.00 for that. Had the rotors drilled to 4 lug...-$20. Then I came across some 30mil aluminum ones. Got those powder coated...-$40 for that.
Sold the iron ones before I even thought about confirming the aluminum ones are/were 30mm. Well, the "30mm" aluminum ones are indeed 26mm.

Here's the dilemma. That flippin' piece of tin that came w/ the rods and springs, can that be used w/ the 26mm calipers although I was told that it's for 30mm? It's a slightly tight squeeze to get it in place, but it'll be a bit comfortable if I clear out the powder coat in the troubled area.

I'm trying to save a few pennies, and I know corners shouldn't be cut when dealing w/ most things, especially brakes.


Thanks.