needed to replace my o2 sensor so i got the innovative mtx-l wideband, which has a o2 sensor that can be calibrated, i got a new set of NGK BKR7EKU's to put in because it was running rich and fouled my current ones, and i did an oil change yesterday, and am doing one right when i install the new plugs and wideband. hopefully the maf cleaner i used will help a little bit if not ill have to replace the maf soon, but this should get my ratio's a little better!

not sure how i want to gap the plugs yet, if anyone has any input on gap sizes please let me know. I have mine currently at .028 but a lot of people are saying they are down to .024 with no problems, I havent had where mine are set but any valuable input is appreciated. also put on my new metal valve cover with gasket, rerouted all my spark plug and vacuum lines to organize it and clean up a bit.

and also when i was taking my IC tubes in and out i found a small leak where it had been rubbing again the rad support, got it welded up and can already notice a difference!

pics.






will take some of the valve cover in the am! too dark when i finished