Originally Posted by
essejms3
scott is the sole person who tuned my speed3 and fucked my motor, bent two rods. shady shitty worthless fucking guy. instead of messing with my tune he just pulled and blocked off a vacuum line to my wastegate with a small bolt.
also fucked another members speed3 up with a tune on another forum also. scott has a bad rep because hes a shady sketchy guy. bottom line. end of story. i hope to god he has a clue what hes doing when it comes to tunning an messing with rotaries, but has no idea what he was doing when he touched my car.
Beware Scott Glassburn
follow this thread for just some surface dirt.
Scott is a great fabricator and very intelligent. He lacks general ethics and business skills. Probably common sense too, but I haven't met him personally to say. He would have stayed in business if he had a partner that would handle everything other than the fabrication and answering intelligent questions.
From what I've seen, BDC does good stuff, but has cracked several irons on the dyno. Not sure if it was fuel, heat, or ignition timing. He also does meth/alky injection only cooling on one of his cars. No intercooler.
I've never met the other two, but I have met and seen Carlos' work. He tuned his a 1030hp (1050hp?) 13b methanol rotary on his dyno as well as a daily driven 505hp 13b on pump gas.