Originally Posted by
JDMB18CYA
haha yea a lot of people seem to get stiffed on TR but hey that's what happens when you take the chances on buying somthing used from a private seller
+1 on the EX tranny.one of the best d series tranny's imo and if im not mistaken is the same as an SI
Yes, I think you're right about the Si. And they are the strongest stock D series with the best gear ratio. Anything else would be a downgrade. haha.
Originally Posted by
HondaHouse
this noise is very, very common is sohc hydro trannys........bearings are cheap...and dont forget the seal either(sometimes it might tear when you pull shft from trans)....
I figured the throw out bearing noise is common, just do to the amount of high mileage trannys nowadays. But I didn't know mine was my input shaft bearing!
Originally Posted by
therecanonlybe1
i can find you a good one with probaly warranty...
I'm supposed to be getting one for $130 bucks tomorrow from a friend of a friend. So at least I know him enough to trust him. If all else fails, I'll definitely let you know. Thank you.
And thank you everyone else! +rep