Originally Posted by
fitbikeco
do it your self. pull intake manifold off 4 12mm bolts each side and then unbolt tgvs from the intake like 4 10mm bolts each side take the butterfly off 2 screws on each butterfly take sensor off eachside and pull the rod out 'slides right out' have holes welded where the rod went through 4 little holes probaly cost you 10$ and really want it to be good grind out the section that is in the port or what ever you want to call it.
way to over-simplify the removal of the intake manifold, lol.
its easier to remove the TGVs and the manifold together, but you need to disconnect the wire harness underneath and the clips for the injectors and disconnect the fuel rail completely and remove it all in one piece.