89-90 chasis use a different compressor that will not bolt up using brackets or anything...

all the lines are different

the condensor / condensor lines / evap / drier EVERYTHING is different...

you can not use ANYTHING from a DOHC chassie


only way to do this is by welding the front condensor line (high side) to the SR high side.. if it comes off of the condensor .. which 99% they are siezed after all these years..

then weld the the low side line SR fitting on to the sohc low side line.


Or you can do it the other way by pulling every line / dash - evap / condensor / dryer..

sorry no cat out of the bag on this one..


martin