i did the newbie thread a while back then made a thread in post your rides but i figured i'd say hello in here since i don't know anyone.

cars a n/a 302 bored 30 over, unported trickflow track heats, victor jr. intake, eagle rotating assembly, cp pistons, wilson spacer, pro systems carb. best so far has been a 6.95 at 104 at lakeland on 28x10.5 m/t stiff sidewall slicks @ 2800lbs. on 275/50r15 BFG drag radials it did 7.05 at 103 weighing 3030lbs. it needs a gear badly and to be lowered about an inch in the rear if possible. its still a stock block car.





and some pics from track event 20 posted in the picture thread by yblegal






Also there is a random steady dripping of water that is coming from inside the front of the bell housing but it only does it every once and a while and it starts and stops speratically. i could run all day and have it not happen, or i could run a few times then it starts then after 10min stops and doesn't do it anymore. anyone have any ideas whats leaking, i'm assuming a freaze plug? its just really wierd