Well guys I wanna go and put together my first engine... This isn't an engine that I am counting on so if I mess up its not a big deal. I just wanna put 1 together and learn as I go. So a couple questions I have as of now is how do I chech for bearing clearence? What tools do I need to check that? What is the right way to put the pistons back in the block? And how do I gap the piston rings on. This is gonna be a ls motor with all ls internals. And like I stated I just wanna learn how to put an engine together. And if in the end it runs lol well then that's a plus.