decided today was going to be my day to install my perrin inlet since my stock one was torn. let me say this was by far the worst project i have ever tried. no only was it a tight fit, the inlet simply did not fit. i actually had to trim it because it was too long, the hard power steering line would not line up, the bov hose would not go on yada yada. took me a total of 4 hours to finish. then i fire her up and what do i find........fuel spraying out from under my manifold on the drivers side. i have had a strong fuel smell everywhere i go for about a month, little did i know it's been spraying all over in my engine bay this whole time. i finally felt done after the inlet and now i get to go spend a bunch of money at mastro since i can't tackle this because i have finals this next week. hooray for me!