i installed my 2.4 it started and reved no problems, i hooked up th turbo and took it down the rd slowly vecause the brakes arent working too good once again no problem but the boost pipes poping off all of a sudden it runs like crap...i figured id may be because i had no map clamp so i installed mine. it still ran like garbage but i was out of gas so i figured that was the problem....well today i put new gas in it and started it and still idles fine but when i give it gas it falls on its face and almost stalls out until i let off th throttle and it idles back fine??? cant figure it out i have a 1:1 and its set at 20 psi i tried moving the top bolt but it made no change in pressure (right now the intercooler is installed but not running into the motor. What else should i look at? its driving me nuts it was fine for so long but i couldnt drive because i had no axels and now i have the axels hooked up and it wont run good