Originally Posted by
Old Renegade
is it idling fine? if the wire were installed wrong it would not fire right and more than likely backfire really bad (i should know
). maybe you do not have the wires secured over the plugs properly. i think .40 is too tight of a gap assuming it is a stock motor. try .45-.48 gap and report back. oh, never change your plugs on a warm ond or hot motor let it cool down first.
it idles fine. it will run for a few mins then at a light it would stall, then ill restart it then it will take 3-4 turns for it to start. it will turn but wont turn over til 3-4 turns of the key. yes its a completely stock motor. its my dd. ill regap them to .45 or so. i looked online and it said .40.
never knew about the last statement on the change of plugs. thanks for the info. ill report back tommorrow morning.