Originally Posted by
civicSi07
i planned on much bigger cams. this is the build i have in mind:
b16 block and head, ctr pistons, eagle h-beam rods, eagle l/w knife edged crank, itr oil pump, itr girdle, blockgaurd, omni power h/c ss valves, O/P titanium retainers, bronze valve guides, prob O/P valve springs, buddyclub spec 4 cams, buddyclub cam gears, new seals and gaskets.
And a good tune from Vega on obd1
sounds like a good plan but alot problems..you will have to groove the Ctr pistons to use on the hbeam rods"i can do it for 45bucks thats includeing locks".dont waste the money on a Eagle crank not needed..the girldes ok but not needed.SPec4 is cutting it VERYVERY close i would stick with Ctr cams....but the head sounds good with Omni.......
i had near the same setup in the black hatch in my galley and ran 13.06 all motor
__________________
i love AUTOZONE
MY CAR iS PROTECTED BY ZOOMBAK GPS LOCATOR IS YOURS?
175+served in engines built from minime to gsr/lsvtec,b16 b20vtec,d15 k24 powerhouses or just rebuilds.life is good
i like when people don't take my advice.cause then i make more money when u need it rebuild the right way!
how many speed holes do i need in my bumper,b4 i can run 15's?