Originally Posted by
TrboANTsi
ok so after leaving work today my car decides to act up. half way home the bitch wont get out of gear i have to rip it out.. getting into gear it gets slammed in. it doesnt seem to release fully and i just dont get it. leaving my work parking lot she was fine. then half way home went to shit. i was mashing my damn car into gear and ijust had the tranny fixed i hope its just the slave cylinder or else i give up again.
A few things to check,
Check your shifter cable linkage, make sure one of the shifter levers arent binding, then check your clutch engaugement/disengaugment.
Slave and master cylinder,
And Fluid level( shouldnt effect putting it in gear but check anyways)
Solid wheel bearings from a skateboard or razor skooter can pop in the shifter cables and make it feel more solid, along with shifter base bushings to the shifter plate. Your whole shift cable alignment can be all screwed up and its setting the gear on the right track. Or if something physically blocking the shift cable from moving up or down it will do that..
Just some thoughts.
Goodluck.