mark:
right now would be a nice time to swap trannys since my car is at the shop getting a new rear main seal and some gasket below that and its behind the drive plate.

however i dont even wanna consider doing a 5speed swap. i am pretty sure the tranny would bolt up because its still in transverse design (mr2 pushing the rear wheels and camry pushing the front) so i dont see any problems with that. but i dunno about the linkage etc. since yours comes from behind and mine would have to have linkage back to my shifter. looking under my dash makes me sick because my remote start alarm (which i can actually keep if i dont use the remote starter unless in neutral) i did install myself and the wiring is like 50 spider webs all in one!

griff: mr2pp uses webcams when you buy em from there. theyre like the same picture too i think.

about the header. you have a 5s-fe it will bolt up. i dont know about clearance problems though. mine extends to my cat which would be almost out the rear end of your car but you could probably get a custom flange or something and custom exhaust. but the bosal is ceramic coated (CC) so you cant weld onto it from what i hear. mr2pps headers are those hotshot? the red one or whatever?

marc let me know what ur willing to just give me the engine and tranny for pricewise? i may just grab it now and can use either the engine parts (rebuild etc) and perhaps slap the tranny on later if i find out it works

later
-dan