View Single Post
Old Sep 3, 2007 | 03:03 PM
  #1 (permalink)  
budakinns's Avatar
budakinns
Big Black Trucking
 
Joined: Aug 2006
Posts: 968
Likes: 0
Default rotary help needed

ok here is the low down. ive own this car for almost a year and it has been leaking the whole time but not a lot. due to no cash coming in was only making enough to pay the bills. now im jobless and the oil is flowing. i toped her off last night so the dip stick was reading full. was omw to do a little photo time with some friends when behold the oil light starts buzzing. i stop and the dip stick is clean. i send my friends to get some oil and i pour 3 quarts and it and the stick shows about 3/4 between low and full. i get home about 15 minute ride and now its about 1/4 inch below the low marking.

ok story done now the question. how much would it cost to do a rebuild as in i do it my self just replacing the gaskets. i think the front housing gasket is shot now i cant tell for sure. there is oil all over the engine bay and what i noticed lately oil shoots up onto the inside of the hood. as i drive start to creep our from the front area of the hood on both sides. if anyone knows anywhere they have cheap gasket kits for a 6 port or even a 6 port just sitting around and want to get rid of it let me know. my pockets are thin so any hook ups would be appreciated. if any rotary people in riverview/brandon area wanna swing by and see if they can spot the leak be my guest.
__________________
Trucking them states
Reply