Originally Posted by
OrOr
I need to extend the bulb pair about 2 1/2 ft. Because this is an all in one ballast/starter, I don't think I can use a relay (see pic in original post). I'm going to buy some thicker than stock wire & test it before installing.
I'm working on it at my house (North Tampa). If I can't get it to work I send you a pm.
Sounds good.
I am in Wesley Chapel if you need any help.
Here's what I have found to work when the current has to travel a distance longer than designed...
The Xenon Store
HID Relay Harness With Inline Fuse Relieves stress on your stock wiring system, or disable your DRL's. By drawing power direct from the battery using all 12 AWG wiring HIDs will turn on when triggered by your headlight switch. Built with a duel output 30Amp Relay it powers both HID ballasts, complete with all needed connectors for easy install, the Relay harness will also provide a level of protection for over voltages to you HID system with its inline fuse.
Black - Ground
White - Switched Source (usually plugs directing into your stock headlight harness)
Yellow/Blue - Plugs into the positive on your HID ballast
Red - 12V+ terminal on your battery
All relay kits are shipped with detailed instructions.