Originally Posted by sprjit22

Thank you sooo much for the info. While u were responding to my post I figured I better go & check my rod bearings. Well I got all green & eagle h beam rods. Im like 100% sure the crank has been turned. I put 1 set of bearings in a rod & started to tighten it to check my clearances & I never finished bc I did the first faze of tightening & their was enough play that I could feel the rod move & when i moved the crank & let the rod hang fee it would just move. wouldent even touch the plasitguage. I think I MIGHT be able to use honda bearings for the mains but I can not for the rods. Im going to take it to the machine shop you told me about & see whatr numbers they give me.

Engine lab of tampa
201 S 78th St
Tampa, FL 33619
(813) 630-2422
Is this correct?