I am putting a b16 sirII motor into my 93 civic hatch. I have the hasport mounts and the cable conversion for the a1 tranny. I bought the hasport linkage for the swap as well. I have energy suspension bushings for the shift linkage. The bushings say they cover a 99-00 civic, 92-95 civic, 92-95 del sol, 92-95 integra gsr, 88-91 crx. so the bushings should cover my 93 hatch, however the shift linkage that I got from hasport doesn't look like it'll fit with the bushings. Namely the bushing at the tranny end that is round and comes in 2 halves ( each being round but with a lip so as to sandwich the ring at the end of the linkage). the bushings are 1.25" dia, and the linkage is atleast a half inch bigger in diameter. I looked at the old linkage ( cut and weld) from my crx swap with the same motor, and the loop at the end matches the hasport linkage. so I am thinking that the bushings were mislabeled and the ones I have are actually for a different car and the stickers just got put on it by mistake. can anyone tell me if they have use the energy suspension bushings for this type of setup? and if so was it a direct fit or did you have to get the bushings for a different year model?

Thanks for the help.