But of course Joe. I already know what outside Dia. I will use for the rotor setup that will still be able to brake "hard" and be as light as possible. Probably going to a couple sets. One with a big rotor(12.19) one with a medium rotor(11.75) and then with something your vehicle weight range if possible a small rotor(10.50). It's going to be a setup with a mounting hat and seperate rotor disk. So some of the dimensions I will need is stuff like center hole dia., face thickness, clearance I.D. and offset. I'll email you a detail sheet with blank dimensions so you can fill it out to make it easier and to double check so I have everything I need. PM me your email.

I will document everything I find with photo's, full detials and any autocad drawings I might have for brackets and all that info will be shared with a few. And yes you are one of them.

Jordan - I will be custom making brackets for the calipers that will be used. I have not decided which set of calipers to go with but they will be 4piston and as light as possible. The rotor Dia. doesn't really matter for what I need as it will be up to the person on what dia. they want to use and then the right bracket for that setup. I'll go look for a detail sheet for what I need and post it up in a second.

Picture- (I need all dimensions on the ride side of the photo and also the over all dimension from the outside of the "face" to the outside of the rotor surface(by outside I mean the part closest to the car).