Thread: milling?
View Single Post
Old Apr 7, 2005 | 06:05 PM
  #9 (permalink)  
TIM TIM TIM's Avatar
TIM TIM TIM
could be worse
 
Joined: Feb 2004
Posts: 11,421
Likes: 0
Default

Yeah the manifold needed to be trimmed a little bit, the gap between the block and manifold was about 3/8's of an inch, it was pretty obvious that it wasnt right. but owell, the only place he knows of is off fletcher somewhere, are there closer ones to waters and sheldon?
__________________
aim:because tim said

www.generationsofcabinetry.com
Reply