wrong.....to put an non obd b16(b16a1) into a 92 hatch you will need either a hydro tranny or cable to hydro conversion kit....also you will need an obd1 distributor or obd2 with modification your injectors out of the sohc(non obd is low impedence and 92+ are high impedence hence the injector resistor box) also you will need linkage & shifter ecu(your choice I recommend chipped p2 rear l bracket all the b16a1 mounts axles del sol vtec throttle cable(your stock one wont fit) external map sensor from a 92-95 dx or newer throttle body with map intact 94-95 del sol vtec outer thermostat housing(or run the wire to the back of the block) and power steering bracket and 94-95 del sol vtec ac bracket......and a few misc items also the b16a1 DOES NOT HAVE A KNOCK SENSOR. If you want you can get a chipped p28 without the knock sensor or drill/tap the top alternator mount hole and put the knock sensor there.....do some research it will pay off. The bad point about the net is you dont know who is giving you advice or if they know anything at all it can be misleading people would rather give bad advice they are unsure of than to admit they know nothing.