I just got back from my welder's shop. Props are due to Marc at Garland Race Shop in Port Richey. I only had rubber 3 tubes available so please pardon the incompleteness of it. These are NOT the final hoses that will be used, they are my first shot at cutting them from a few months ago. The final product will look cleaner and neater. This will go on my stock B18C-R motor that recently put down 178whp. The motor will stay stock until I get my cams.
I will not go into my expectations, this thread is just for pics. At least right now.
So, without any further ado, here we go.
Hmmm, what happened to the rest of the intake manifold??
Final product, sandblasted clean.
Side shot
A 20 ton press comes in handy !!
Look at those runners, can you see the weld line ??
Looking through 50mm of fury, Gixxer 1000 style !!
Open wide !!!
Trial setup
Final shot
