no chin, the motor wont tilt far enough back, i can't even get the input shaft in the clutch disk. im lucky it was able to squeez in to the center of the pressure plate area. i have done this a dozen or so times on my Z and other's Zs NA and TT and never had a problem like this.

AFAIK guys the mounts are stock KA ones. but they look like nismos from the pics i have seen. so i don't know. i put a jack under the front of the motor, with a board, not to dent it. and tilted it back. im sooo Fn close, about .25- .3 of an inch then the damn AC line started hissing.

i'll try again tomorrow for an hour, if i can't get it to go in. im yanking it. i have already spent enough time on it that i could have already done that. =\

thanks for the help guys.