Originally posted by 40ozCasualty
I'm using a PM6 ECU, I was told I could run the ODB1 Distributor, as long as I convert the OBD1 plugs with my OBD0 plugs, and I'm using plugs from an Si. I was under the impression that all the sensors in the distributor are the same. I'm pretty sure if I wire it up correctly it should work.
(Still need to know about this BARO sensor, I'm assuming its like a map sensor, Just don't know where it is or what it looks like.)
NO. You can not run the OBD1 distributor with the OBD0 ecu. Kick that guy in the nuts who told you that. The trigger wheel count is different between the OBD0 and OBD1/2 distributors. The baro sensor is on the firewall for the OBD0 setup and inside the ecu for the OBD1/2 ecus.