alright guys, i installed a exedy 3 puck with 6 springs and a pressure plate, I resurfaced my flywheel to .610 and used the alignment tool and got a new TOB. the clutch fork and pivot ball are both in good shape and they are now greased. I torqued everything and put it all back together...start car and half the pedal is play and then it gets firm at the end. i re-bled the system and adjusted the pedel under the dash. same thing. master cyl is WET but not leaking. its been wet for years. the slave is a little wet on the inside so i bought a new slave cyl. (im installing it sometime today) i couldnt find any noticeable leaks in the hydrualic system at all. once in a great while i can shift into 2-3-4 gears with the new clutch setup. car hasnt moved yet becuase i cant get it into first. i noticed when i took my slave off that i could push the clutch fork forward and backwords and it doesnt hit anything. i installed the clip to keep the tob in. but isnt it supposed to hit the pressure plate??? I really hope i can fix this problem without tearing the tranny out. someone help!! when car is off i can get into all gears fine.