William Branan
williamb82@yahoo.com
813-900-0677
Spring Hill, Fl. 34608

while condensing the mess in the garage i found alot of stuff i dont need and some i forgot i even had. here is what ive dug out so far.

injectors have not been cleaned or tested

6 denso 208cc/min high impedence injectors. 23250-16080 $50 shipped obo.
http://witchhunter.com/flowdatapix/d2325016080.jpg


5 denso 192cc/min high impedance injectors. 23250-62020 $30shipped obo.
http://witchhunter.com/flowdatapix/d2325062020.jpg


88 celica alltrac ct26 turbine housing. smaller a/r than the supra one for faster spool. $50 plus shipping (alltrac on the left)



7mgte coil pack. no harness. $40 plus shipping.


7mgte bottom end. needs rebuild. $100 pickup only.


4 cop dual post coils for a cop setup. came off of 2 4cyls. would be good for a 1uz swap or a 5m/6m/7m/1j/2j on waste spark and have a coil left over. $80 shipped.



stock mk3 turbo boost pressure sensor. for the gauge i believe.no pigtail. $15 shipped.



Bosch 3 channel "HOT" ignitors from a volvo. iirc a s60. it was a newer straight 6 with a cop setup. $40 shipped each or $70 shipped for both.



mk3 switches. driver side window. both console panel switches and 2 coin holders. $30 shipped for them all. had them a long time so as is. no way to test as i dont have a mk3.

 

94-95 3vzfe 6 channel ignitors with pigtails. from 94-95 es300's and v6 camry's with cop. $40 shipped each.


ford pwm controlled idle solinoid. works with megasquirt. $30 shipped.



7mgte igniter $60 shipped. worked when removed.


7mgte swap oil pump pickup tube. from my first 7mgte swap. worked great, but when i moved the swap to a different mk2 i used a 5m pump instead. will need to be cleaned for sure. $20 shipped.


5 ignition coils for a 88 nissan pulsar. plus the coil harness. $30 shipped.


1st gen ls400 1uz-fe igniters. $50 shipped for the pair.


7mgte 90deg oil filter adapters. $20 shipped each.


1st gen ls400 egr pipe. this is prone to cracking. cracks have been welded the entire way around. no leaks. $20 plus shipping.


7mgte "3000" pipes. $10 each plus shipping. one sold


stock ct26 turbo. had this thing for over 10 years. forgot about it. i know the rear seal was leaking, and thats why i replaced the turbo. as far as i know thats all thats wrong so its rebuildable. couldnt find the oil lines or wastegate actuator. $50 plus shipping.

 

7mge n/a valve covers. started stripping them to polish, never finished. $40 plus shipping.


7m cams. not sure but i beleive all are 7mgte cams. far right. $80 plus shipping. 2nd from the right, $60 plus shipping. 2 sets on the left $30 plus shipping each. would prolly make a good core for regrinds. again, forgot i even had these.


7m lower intake for 6 additional injectors with 6an fuel rail. $150 shipped obo.




2jzgte jdm water pump and rear housing for hydro radiator fan $50 plus shipping.



DSM stock intercooler. $20 plus shipping


mk3 drop in k&n filter. came on my 88 turbo donor years ago. $20 plus shipping.



vintage sbc torker intake. needs to be repolished with a mothers ball and polish. $200 plus shipping. this is an original torker, not a torker 2.

 

sbc headman long tube headers. the black on them is the original paint. $150 plus shipping obo.



7m upper timing covers. $10 each plus shipping.


complete 7mgte with ms2, 4bar map, 780cc/min injectors, 57 trim ct26, cop, 3in dp, aem wideband, arp headstuds, 50mm tial style bov, stock mk3 i/c and 2in piping, cone air filter. runs but needs rebuilt. $2000obo complete.

 

ssr's sold

 

removed the parts that are sold. Also have a 3tc ported cylinder head. $300 obo. it has new valve stem seals and new spark plug tube seals in it. i have most of a headgasket kit to go with it. was for a friends project that he no longer has. no other 3tc parts, just this head and some gaskets.