WTB full running turn key turbo swap (CASH IN HAND)
Thread Starter
Nissan Parts Go to Guy!
Joined: Aug 2007
Posts: 650
Likes: 0
Clean S13 SR, fresh front and rear main seals just installed
Custom non ballbearing T28, Nismo GTR exhaust side (same as GTiR but clipped wheel, GTiR .86 exhaust housing, Garrett GT28RS "disco potato" compressor side (should be good for 350 whp or so)
Tuned ecu for 550s/zmaf
Ogura ORC single clutch (used)
Good transmission
Trust FMIC
Greddy inlet and outlet elbows for S13 install
Engine has all front stuff except a/c compressor/bracket, currently anyway.
Depending on when you're interested or if we can work a deal, some of the other parts i'm actively searching for, or just procrastinating on ordering may be available too:
New engine harness
N62 MAFS
550's
Outlet elbow
Downpipe
Custom non ballbearing T28, Nismo GTR exhaust side (same as GTiR but clipped wheel, GTiR .86 exhaust housing, Garrett GT28RS "disco potato" compressor side (should be good for 350 whp or so)
Tuned ecu for 550s/zmaf
Ogura ORC single clutch (used)
Good transmission
Trust FMIC
Greddy inlet and outlet elbows for S13 install
Engine has all front stuff except a/c compressor/bracket, currently anyway.
Depending on when you're interested or if we can work a deal, some of the other parts i'm actively searching for, or just procrastinating on ordering may be available too:
New engine harness
N62 MAFS
550's
Outlet elbow
Downpipe
__________________
Doesnt see what you did
Joined: Sep 2007
Posts: 3,683
Likes: 0
Make an offer, if it's reasonable i'll consider it, dont really want to sell as is, however it would be cool to just get my other engine running, rather than installing this setup to drive around for a little bit first.
cant slide
Joined: May 2008
Posts: 2,441
Likes: 0
Thread Starter
Nissan Parts Go to Guy!
Joined: Aug 2007
Posts: 650
Likes: 0
