WTT 4cylinder turbo stang for 240...
this is testing waters, but also might very well be willing to trade my car. i can throw money on top or u can or straight trade... idk yet we'll see!
ok so heres some car specs for you guys.
car: ford mustang, 1991 hatch lx
engine: 2.3L sohc 9:1 compression, turbo charged, fmic ebay tial bov and wastegate. full 3inch exhaust, mandral bent after downpipe. full stand alone unit in car. rotated upper intake, 36lb injectors, relocated battery. tubular top mount shorty turbo header by stinger, 1/2in turbo flange spancer to clear turbo cold side and header
turbo: unbranded garret TO4E "o" trim turbo, 61mm, 3in intake, 3 in. v-band exhaust housing. t3/t4, wet float ball bearing turbo.
trans.: t-5 5-speed manual with aftermarket zoom clutch, pressure plate, and flywheel, steeda tri-ax short throw shifter, high performance clutch cable and billet alum. clutch quadrant.
rear end: built 8.8inch rear end, posi with 3.73 gears BRAND NEW BUILT REAR END!!
just finished running piping and relocating battery to the trunk and rotating the intake.
wheels and tires: brand new KR500 17x9 rims, 275x40x17 rubbers UP FRONT!!
DEEP DISH KR500 17x10.5 rims out back, 315x35x17 (12.25 inchs of tire under each rear fender.
suspension: 2 inch drop. rear springs are BBK lunch springs,
full SN95 5-lug swap
(comes with 2004 mustang wheels and tires too for difting or beating on too.)
PRO'S AND CON'S!!!!
pro's:
anything aftermarket is brand new. and has less then 100miles on the including the brand new wheels and tires. cars driven less than 85-100miles.
has a 2 pod piller with oil and boost, and has a wide band and water temp mounted into the dash, a fuel pressure guage mounted in cowl hood, along with a 5in monster tach. all auto meter sport comp silver on silver guages,($800 in guages) black interior, rust free car minus the hatch, i can get a rust free hatch for you though.
anything this car has other than bov and waste gate is name brand and top of the line and brand new to boot. this car also comes with a spare block and head. forged internals at 8:1 compression and a turbo head.
both rebuilt and just waiting to be put in the car.
car has all a/c parts just not hooked up.
power steering and braking, no electrical problems.
i,ve put well over $6k into this car! another 500 and you have a strong 500whp mustang that'll break necks at car shows and the street races!
CARS GETTING PAINTED SOON!! all body work and paint will be on car and finished before its picked up for trade unless otherwise noted. also if it is painted i'll be throwing the other block and head in the car. (3-4 weeks from now)
cons:
engine in car is an N/A block and head. they dont like boost and flow like shit... (nice block and head included!!)
stand alone unit has been tricky and i would buy an ems pro from spectre and wiring the car over a weekend. because this stand alone is wired in a ecu box and uses the stock wiring harness of the car. bad thing is the car wont take tune...
also has two oil leaks which i will fix upon request.
.
overview? ok
this car needs almost no real work to be at 500+ wheel horse power.
it will have sexy white on black two-tone paint, 1300$ in wheels and tires, 500$ in guages, 1k in stand alone unit, freshly built engine, built rear end and 85% built tranny! u'll be getting a new car. it just needs a little work on the stand alone side of things really.
depending on ur car i can have mine running and driving, and painted and totally tuned and finished or as is (needing paint, stand alone, wiring and block and head swapped, oh and tuning)
honestly i want a run of the mill nissan 240, hatch or coupe. s13 is ok but rather have an s14. must be boosted KA-T or SR ( or RB/1jzgte swapped)
i'll post nice pictures later but these shmitty ones will hold u guys over i hope.
thanks for looking and offer up!!
heres how you can reach me!
727-234-5686 (call, text, send pics)
tyler103bob11 @ yahoo . com


thanks!!
-tye braun
ok so heres some car specs for you guys.
car: ford mustang, 1991 hatch lx
engine: 2.3L sohc 9:1 compression, turbo charged, fmic ebay tial bov and wastegate. full 3inch exhaust, mandral bent after downpipe. full stand alone unit in car. rotated upper intake, 36lb injectors, relocated battery. tubular top mount shorty turbo header by stinger, 1/2in turbo flange spancer to clear turbo cold side and header

turbo: unbranded garret TO4E "o" trim turbo, 61mm, 3in intake, 3 in. v-band exhaust housing. t3/t4, wet float ball bearing turbo.
trans.: t-5 5-speed manual with aftermarket zoom clutch, pressure plate, and flywheel, steeda tri-ax short throw shifter, high performance clutch cable and billet alum. clutch quadrant.
rear end: built 8.8inch rear end, posi with 3.73 gears BRAND NEW BUILT REAR END!!
just finished running piping and relocating battery to the trunk and rotating the intake.
wheels and tires: brand new KR500 17x9 rims, 275x40x17 rubbers UP FRONT!!
DEEP DISH KR500 17x10.5 rims out back, 315x35x17 (12.25 inchs of tire under each rear fender.
suspension: 2 inch drop. rear springs are BBK lunch springs,
full SN95 5-lug swap
(comes with 2004 mustang wheels and tires too for difting or beating on too.)
PRO'S AND CON'S!!!!
pro's:
anything aftermarket is brand new. and has less then 100miles on the including the brand new wheels and tires. cars driven less than 85-100miles.
has a 2 pod piller with oil and boost, and has a wide band and water temp mounted into the dash, a fuel pressure guage mounted in cowl hood, along with a 5in monster tach. all auto meter sport comp silver on silver guages,($800 in guages) black interior, rust free car minus the hatch, i can get a rust free hatch for you though.
anything this car has other than bov and waste gate is name brand and top of the line and brand new to boot. this car also comes with a spare block and head. forged internals at 8:1 compression and a turbo head.
both rebuilt and just waiting to be put in the car.
car has all a/c parts just not hooked up.
power steering and braking, no electrical problems.
i,ve put well over $6k into this car! another 500 and you have a strong 500whp mustang that'll break necks at car shows and the street races!
CARS GETTING PAINTED SOON!! all body work and paint will be on car and finished before its picked up for trade unless otherwise noted. also if it is painted i'll be throwing the other block and head in the car. (3-4 weeks from now)
cons:
engine in car is an N/A block and head. they dont like boost and flow like shit... (nice block and head included!!)
stand alone unit has been tricky and i would buy an ems pro from spectre and wiring the car over a weekend. because this stand alone is wired in a ecu box and uses the stock wiring harness of the car. bad thing is the car wont take tune...
also has two oil leaks which i will fix upon request.
.
overview? ok
this car needs almost no real work to be at 500+ wheel horse power.
it will have sexy white on black two-tone paint, 1300$ in wheels and tires, 500$ in guages, 1k in stand alone unit, freshly built engine, built rear end and 85% built tranny! u'll be getting a new car. it just needs a little work on the stand alone side of things really.
depending on ur car i can have mine running and driving, and painted and totally tuned and finished or as is (needing paint, stand alone, wiring and block and head swapped, oh and tuning)
honestly i want a run of the mill nissan 240, hatch or coupe. s13 is ok but rather have an s14. must be boosted KA-T or SR ( or RB/1jzgte swapped)

i'll post nice pictures later but these shmitty ones will hold u guys over i hope.
thanks for looking and offer up!!
heres how you can reach me!
727-234-5686 (call, text, send pics)
tyler103bob11 @ yahoo . com


thanks!!
-tye braun
__________________

TB CUSTOMS. top notch work shouldnt cost you top notch money. we'll beat any other companys custom fabrication and weld quotes and support you with an amazing warrenty.
727-768-2967 call or text
facebook us
http://www.facebook.com/home.php#!/h...059440077&ap=1

TB CUSTOMS. top notch work shouldnt cost you top notch money. we'll beat any other companys custom fabrication and weld quotes and support you with an amazing warrenty.
727-768-2967 call or text
facebook us
http://www.facebook.com/home.php#!/h...059440077&ap=1
Last edited by 23tstang; Jun 2, 2010 at 04:29 PM.
thanks guys
__________________

TB CUSTOMS. top notch work shouldnt cost you top notch money. we'll beat any other companys custom fabrication and weld quotes and support you with an amazing warrenty.
727-768-2967 call or text
facebook us
http://www.facebook.com/home.php#!/h...059440077&ap=1

TB CUSTOMS. top notch work shouldnt cost you top notch money. we'll beat any other companys custom fabrication and weld quotes and support you with an amazing warrenty.
727-768-2967 call or text
facebook us
http://www.facebook.com/home.php#!/h...059440077&ap=1
gotta get some pics in thee of the car man..... interior, better ext pics...
__________________
Branden Berger
352-789-0006
86.5 toyota supra- 1jz never to be finished
01 mitsu eclipse v6 5mt chick car daily
98 honda accord ex- h22 swapped daily driver
Branden Berger
352-789-0006
86.5 toyota supra- 1jz never to be finished
01 mitsu eclipse v6 5mt chick car daily
98 honda accord ex- h22 swapped daily driver

-tye
727-234-5686
__________________

TB CUSTOMS. top notch work shouldnt cost you top notch money. we'll beat any other companys custom fabrication and weld quotes and support you with an amazing warrenty.
727-768-2967 call or text
facebook us
http://www.facebook.com/home.php#!/h...059440077&ap=1

TB CUSTOMS. top notch work shouldnt cost you top notch money. we'll beat any other companys custom fabrication and weld quotes and support you with an amazing warrenty.
727-768-2967 call or text
facebook us
http://www.facebook.com/home.php#!/h...059440077&ap=1
to da top please!! lol. anybody wanna bad ass boosted 2.3l mustang???
cause i want a bad ass boosted 240! ka-t or sr or whatever swap u got!
p m me or text/ call me!
-Tye
cause i want a bad ass boosted 240! ka-t or sr or whatever swap u got!
p m me or text/ call me!
-Tye
__________________

TB CUSTOMS. top notch work shouldnt cost you top notch money. we'll beat any other companys custom fabrication and weld quotes and support you with an amazing warrenty.
727-768-2967 call or text
facebook us
http://www.facebook.com/home.php#!/h...059440077&ap=1

TB CUSTOMS. top notch work shouldnt cost you top notch money. we'll beat any other companys custom fabrication and weld quotes and support you with an amazing warrenty.
727-768-2967 call or text
facebook us
http://www.facebook.com/home.php#!/h...059440077&ap=1
pictures to be posted soon.
__________________

TB CUSTOMS. top notch work shouldnt cost you top notch money. we'll beat any other companys custom fabrication and weld quotes and support you with an amazing warrenty.
727-768-2967 call or text
facebook us
http://www.facebook.com/home.php#!/h...059440077&ap=1

TB CUSTOMS. top notch work shouldnt cost you top notch money. we'll beat any other companys custom fabrication and weld quotes and support you with an amazing warrenty.
727-768-2967 call or text
facebook us
http://www.facebook.com/home.php#!/h...059440077&ap=1
hey im interested to see pic i really like the way it looks and i always loved the 2.3 i have a 03 srt4 to trade u its pretty much stock just bolt ons it has about 87k on it runs great could use some front tires tho let me see some better pics tho first





Bump for someone who wants to cross over