tommy, just to make sure, that water neck has the hole for a coolant line right??


also, that flywheel, exactly how bad is it? still useable? or desperately needing resurfacing?

 

Yes its the S14 neck with the hole for coolant.

Installing a clutch without resurfacing is stupid, its like $20 to get one resurfaced.

 

get on AIM and hit me up.... ready to buy! that and the water neck!

 

I wish the s14 and s13 Intake Manifold's were the same.

Good seller

 

would u take any less for harness

 

Its already priced near a stock non ready to plug in S13 harness, and has had all the work for install into an S13 done, are you kidding ?

 

Just buy the head, then you can run the intake

Gotta love it when this one occurs
The following errors occurred when this message was submitted:

1. This forum requires that you wait 45 seconds between posts. Please try again in 1 seconds.

 

Would it be possible to re-wire that harness for an S14?

Either way I want the lower oil-pan, 5spd trans, coil-pack/harness, Ignitor, coil-packs.

I can pick it all up this weekend.

 

Dan that would be a lot of splicing to put it back together at the F3/4 plug, I really wouldnt suggest it, im not sure what good non cut S14 harnesses go for, but I would think you'd be better off going with one in this case.

 

New they run around 400$ But I'll just look else where for one.

anyways I want that other stuff I mentioned if you still have it this weekend.