bobnissan

This Set up Made 543 hp and 463 lbs of torque on 26 psi (~11.3-11.5 A/F on C16).


MOTOR (RB25DET 1997 SII) & Transmission (Mines Short Shifter-RPS Clutch-Less than 2000 Miles) Motor has the following internally........
-CP Pistons (Bored .020 over
-Calico Coated Rods & Main Bearings -1.2mm Greddy Head Gasket
-ARP Head Studs -Ported & Polished head -5 Angle Valve Job
-New Valve Stem Seals -Shot Peened Rods -Power Enterprise Timing Belt
-NISMO tensioner -RB25DET Gasket Kit -New Water Pump (OEM)
-Motor Freshly Re-assembled by P.C.C Automotive in Summer of '05
Built by Dennis 407 933 5889 (He built the Motor) Have receipts of build up (Labor over $1000)-**Motor has less then 2000 Miles**
Oil Pump needs replacing with Aftermarket.
Motor is 8:0:1, 8:5:1 CP Pistons, with a 1.4mm Head Gasket
Greddy Intake Manifold Q45 Throttle Body
Dual Feed Fuel Rail (Custom)
ENGINE MANAGEMENT
Microtech LT-12 (3 Bar Map Sensor / Engine harness wired for RB25DET / 240sx) You will Need your OEM Lower Harness
TURBO KIT / MANIFOLD
-Custom Equal Length Exhaust Manifold (Made by Gato 407 943 7300)
-GT40/Turbo/67 .81 A/R T4 Flange (Rated for 780whp) -3.5" Downpipe
DRIVETRAIN
-Custom Driveshaft
-Custom Solid Motormounts and bolts (Also have other MM)
*Maybe forgeting a few parts*
If YOU FEEL THE PRICE IS HIGH* Please make an offer or suggest a 'reasonable price'.....



Selling for $6100 O.B.O
Taking ALL REASONABLE OFFERS, MUST SELL A.S.A.P !!
As i stated above, I will part out, if MOST of it gets SOLD.

PM OR E-mail --> J_Kirat@Hotmail.com
AIM: Slowasssilvia

bobnissan

Ill take 5800 for EVERYTHING LISTED NEW PRICCE

SplitInfiniti

is the motor already pulled from the car??

bobnissan

The motor is still in the car. The microtech and all the piping is not on the motor. I plan to pull the motor this weekend.

Anthony R

damn, bump 4 a clean ass car, and 4 a good deal. best of luck.