Alright guys i am in need of $$$$ since i am moving from Orlando to Marietta GA with in the next 2 weeks. I am selling fully built 6 bolt stroker with head or i could part out the block and head if i get buyer interested on both items.
Engine have less then 3k miles and runs stron. Never saw more then 20 psi on a sc61. I am trying to sell this quick so i asking $1500 obo. Thanks

Head:
-280 Crower Cams
-SI Dual Valve Springs
-SI TI Retainers
-SI 1mm Over Valves

Block
-2.4 Machined Crank
-Wiseco Pistons 8:8:1 020" over
-Eagle Rods
-Arp Head Studs
-Clevite Bearings, stock main bolts
-No balance shafts, hole plugged

 

Bump OBO guys need to move this.

 

just curious what kind of power u made with that setup?

 

Never got to push it, only ran the engine when i had a sc6169 and was only running 20lb of boost. Wasn't tuned either, soon after that I crashed the car and i have had the engine sitting since then.

 

If this were available 4 months from now I'd be all over it. I'm so afraid the stroker I bought is going to shit on me that I want to build one, or at least know it was built properly before running it.

 

Wish i could help you there buddy, but i am moving everything to GA in a couple of weeks. Best of luck with your current engine.

 

Who assembled the motor, what were the clearances, and where are the pics?

 

[ATTACH=CONFIG]160671[/ATTACH][ATTACH=CONFIG]160672[/ATTACH][ATTACH=CONFIG]160673[/ATTACH][ATTACH=CONFIG]160674[/ATTACH][ATTACH=CONFIG]160675[/ATTACH]

 

[ATTACH=CONFIG]160676[/ATTACH][ATTACH=CONFIG]160677[/ATTACH][ATTACH=CONFIG]160678[/ATTACH][ATTACH=CONFIG]160679[/ATTACH]

 

James at 1ST Choice Auto in Orlando assembled the engine.