OK i need a set of studs or bolts to bolt my turbo to mani...i have a 2g dsm mani... and a 13g turbo...lmk if anyone has this or is thsi something i can go and get at a hardware store!! lmk!!

thanks guys!

 

go to A&N bolts and fittings on Anderson RD. they have the best stuff. high quality at a low price.

 

got an address? thanks man...

 

No i don't, but just take hillsborough to Anderson, not hoover. turn and it will be on your left hand side. i beleive there is a Citgo on the corner of hill and anderson. and you go down a little an the left there will be like some industial buildings, and it is in there. it looks like a ware house kinda, but they serve the public as well.

 

ace hardware

 

They don't have anything good enough to use in that heat.

 

my bolts are working just fine and cuban/Prince

 

Have you taken them out yet? I had an ACE bolt seize in badly because of the heat then snap when I tried to remove it, requiring a trip to the machine shop to have them drill it out. The stock bolts are Grade 11 (really friggin high grade tough stuff) and the ACE bolts are 8.8 or something like that.

Anyway, this is moot, you should buy new bolts from the dealership is the best answer I can give. New bolts, new 2g double crush washers (2 per bolt), *edit*and don't forget a new gasket*/edit* some Loctite Copper Antiseize (they sell it in sticks at discount) and torque it properly (40-47 ft lbs) and she shouldn't come loose until you want her to. Used bolts are bad news, they can be worn out and come loose easily. If you want the easiest place to order this stuff from, www.jnztuning.com

 

This has devolved into more of a tech thread... thread poster, I recommend buying new. If anybody has any bolts for him, send him a PM.