I got a k20a3 semi built motor that consist of: Crower rods, Cp pistons 9to1 compression, ARP head bolts, Cosmetic head gasket, new seals, gaskets, bearings, and so on. the head is stock but has the valves replaced. The work was done by brothers racing then finish at Central Florida Turbos. I have all the paper work and dyno sheets. This motor only has about 6k miles on it which was run on 10lbs tune. All the motor needs are the wire harness , tranny, and clutch,throttle body and kpro those have been sold already. I currently took it out to place it in a crx for a drag car but just got carry up in fund due to college. This motor is set for 600hp according to Brothers, and CFT. The motor is set for turbo , it has the tap oil pans and all . Asking 1600 obo or would consider trades like firearms or anything that kind of nature. Thanks

 

Up

 

Bump

 

bump