ok heres the deal, was going to sell my built single but ran into a problem. did a compression test on motor today and found out that #3 was about 20psi then it should be so we broke down the motor and found out that the piston was fractured but not broke. joy! so im just going to sell everything so i can get up the money to get a dohc motor, here we go.


block:
d16z6- bore .50 over with vitara pistons and bc h beam rods, apr rodbolts, arp head bolts

head:
d16z6- purple series valve springs and retainers, crower stage 3 turbo cam, skunk2 cam gear
d16y8- stock was going to get it worked but not anymore

intake:
edlebrook intake manifold with 63mm throttle body

tubo set up:
50/63 m-series from turbo.com, spa cast top mounted a/c friendly turbo manifold with xspower 38mm waste gate, with full 3 inch down pipe and exhaust

intercooler:
not sure the messurements but its big jdm password, u can see in the pics

misc:
greddy sandwich plate and oil catch can

electronics:
greddy turbo timer
apexi afc neo
and inside manual boost controller
aem wideband
autometter boost, oil pressure, exhaust temp

tranny:
d16y8- needed the longer gears, with act stage 4 6puck sprung

i want everyone to make an offer on everything, i know tr and im not going to let u take anything from me. if you have any question u can text me at 8633324720 thanks. p.s. sorry for the big pics

 

ill get more detailed pic tomorrow

 

How much for the Intake Manifold?

 

text ya

 

pmed and texted back

 

ttt

 

how much 4 the block and turbo mani??

pm me

 

pmed
and thanks for all the messages ttt

 

ttt

 

ttt