need motor blown perferably.....dont want one with hole in block.....dont care if it had spun rod bearing ECT...... just need one cheap

 

bump

 

i got a whole swap minus wire harness d16(non-tec) $500 lmk

 

ill have one here in a few days. its a 1991 d16a6 non vtec. ill be pulling the crankshaft, rod, and possibly a piston out of cylinder numero 1. other than that, the motor ran when pulled out of a friend's hatch. the block is ready for a vtec head cause i pulled out the little pin thing in the block (can easily be pushed back in). but i do have the original head, and everything on the head and block looks fine.

LMK 150. ill throw in a hydro tranny at no extra cost.

 

bump for a friend

 

mines a 97 wit 90k on it still in car if you want to test drive

 

ttt

 

u just need a bare block i got one with mains in beautiful shape walls are perfect has everything minue crank rods and pistons 25bucks Y8

 

bump

 

I got one, you can check my thread if ya want, but it's an almost complete swap for real cheap, nothing wrong with the motor, no burning oil nothing. It's been sitting since january of this year, want it gone. check out my thread.