Parting out d16z6
Thread Starter
Registered User
Joined: Apr 2005
Posts: 255
Likes: 0
Parting out d16z6
I have a complete d16z6 longblock that im parting out.....the bad thing is that it has a spun rod bearing. the head is mint.. has a 3 anlgle valve job with port and polishing. have all invoices. pistons are fine, block itself is fine.
Motor includes the following:
complete and assemble long block
dizzy
engine harness
intake manifold
alternator
powersteering stuff
head is complete and in perfect condition, has about 10,000 miles on it
I was going over bayside last night when i spooled up to 13psi...i didnt look at the guage and i spun the bearing. shit happens
I will part out or sell the whole long block for $300.
Motor includes the following:
complete and assemble long block
dizzy
engine harness
intake manifold
alternator
powersteering stuff
head is complete and in perfect condition, has about 10,000 miles on it
I was going over bayside last night when i spooled up to 13psi...i didnt look at the guage and i spun the bearing. shit happens
I will part out or sell the whole long block for $300.
__________________
Got vtec?
Got vtec?
engine building &amp;amp;best
Joined: May 2003
Posts: 11,971
Likes: 0
you sure its the bearing and not a cracked sleeve?if so i will buy it from you im in tampa
__________________
i love AUTOZONE
MY CAR iS PROTECTED BY ZOOMBAK GPS LOCATOR IS YOURS?
175+served in engines built from minime to gsr/lsvtec,b16 b20vtec,d15 k24 powerhouses or just rebuilds.life is good
i like when people don't take my advice.cause then i make more money when u need it rebuild the right way!
how many speed holes do i need in my bumper,b4 i can run 15's?
i love AUTOZONE
MY CAR iS PROTECTED BY ZOOMBAK GPS LOCATOR IS YOURS?
175+served in engines built from minime to gsr/lsvtec,b16 b20vtec,d15 k24 powerhouses or just rebuilds.life is good
i like when people don't take my advice.cause then i make more money when u need it rebuild the right way!
how many speed holes do i need in my bumper,b4 i can run 15's?
