I have a near complete swap for sale. This is my personal motor that was ran in both my civic hatch and crx.

Longblock:
92 b18a1 block, balanced ls crank, stock ls rods with arp rod bolts, oversized type pistons (USDM about 11:1 comp), new ITR oil and water pumps with less than 500 miles, new seals and o rings in bottom end (less than 500 miles), OEM bearings. The rotating assembly has about 40,000 miles on it since rebuild, pumps and seals less than 500. Timing belt also has 500 miles.

Cylinder head is a first gen b16a head with a fresh 3 angle valve job, new itr/portflow spring combo, new valve seals, GSR cams, stock cam gears, new lost motion assemblies. Head was rebuilt 500 miles ago.

Longblock is completely assembled and ready to run, also comes with a obd1 gsr distributor, ITR intake manifold with hondata int gasket, OEM header.

Transmission + drivetrain:
92 GSR ys1 tranny, Kaaz LSD. Tranny grinds second and third, needs new second gear and syncro set and a third gear syncro set to be mint again. This lsd works really well for road racing and autocross. About 7k miles on lsd. Stock flywheel and ACT street/strip clutch with less than 2k miles on it.

Also included with swap:
-stock axles and intermediate shaft (90-93 teg)
-Hasport motor mounts (Race)
-OEM SIR linkage, does not get better than this for shift quality.

Basically everything needed for a swap into an ef with the exception of an ecu and wiring harness. I can also include an obd0 to obd1 ecu harness for an additional $75

Asking $2500 obo but I'll entertain any reasonable offers.

 

I do not want to part but I'll consider it if I get a decent offer for either the longblock or tranny. I WILL not seperate the head and block and Iwill not sell the axles or other small items unless someone buys the longblock or tranny first.

 

pic of motor in my old crx

 

ttt

 

free bump for one of the nicest mofo's around

 

ttt

 

How much for the complete longblock (dizzy, intake and exhaust manifolds) minus the clutch/flywheel?

 

what would i need to put that in my crx?

 

a engine hoist and some wiring.

ttt for kevin

 

make me an offer.