Great job dude! Deff come along way.

 

Went over to Bryans shop to throw the engine and trans in the car today. I am going in for back surgery on tuesday and wont be doing any kind of lifting for quite a while. With the car/engine on the stand/engine hoist/butt load of parts and my wifes car the garage was getting packed. So this will free up alot of space and all the heavy lifting is done. Here are a few pics, thanks for the help Bryan!!!

 

I kick myself in the ass for going as deep into my project as I have....looks good Chris...Hope for a speedy recovery after your back surgery

 

Thanks bro, I appreciate it.

 

So whats the engine? If you posted spec's, I didn't see em.

 

Nothing real crazy. Stock bottom end, twisted wedge heads, f-cam, wiend intake, Frank TF special carb and a 70mm turbo. I know I might get some shit for the turbo that I got. its an ON3 kit, but the reason I went with it, is that I got the whole turbo kit with an upgraded intercooler and a custom 3" exhaust all the way back to the axle for a great price. If I have to upgrade the headers or other parts down the road, then so be it. This car MIGHT get driven a few thousand miles a year.

 

Ok got some updates for you guys. Got the car back from paint (Thanks Bryan!) and re-painted the bottom of the car again. Finished the hot side of the turbo, dropped the gas tank and put the carb pick up, ran the fuel lines part way, mounted the fuel pump/filter, hooked up power steering lines, took the junk run channels (weatherstripping) out of the doors, hooked up the starter and all the wiring, installed door locks and handles, set the pinion angle and installed driveshaft, finished the trunk area off etc. Still have a TON of stuff to do, but knocking it out slowly. Here are some pics

 

damn chris the car looks great makes me want a coupe again lol keep up the great work